[Free] 2019(Nov) EnsurePass Juniper JN0-102 Dumps with VCE and PDF 281-290

Get Full Version of the Exam
http://www.EnsurePass.com/JN0-102.html

Question No.281

Which statement describes an advantage of dynamic routing?

  1. Dynamic routing is typically more scalable when compared to static routing.

  2. Unlike static routing, dynamic routing requires no initial user configuration.

  3. Unlike static routing, dynamic routing provides redundant IP addresses for end-user devices.

  4. Dynamic routing provides DNS services along with IP connectivity, whereas static routing does not.

Correct Answer: A

Question No.282

Which class-of-service component allows you to define the bandwidth allocated to different traffic types?

  1. classification

  2. rewrite marking

  3. scheduling

  4. queuing

Correct Answer: C

Question No.283

What are three valid match criteria in a firewall filter applied to a Layer 3 interface? (Choose three.)

  1. IP address

  2. MAC address

  3. protocol

  4. port

  5. session ID

Correct Answer: ACD

Question No.284

Which operational command would you use to quickly verify the state of all interfaces?

  1. show interfaces terse

  2. show interfaces

  3. show configuration interfaces

  4. show interface status

Correct Answer: A

Question No.285

During a password recovery, what is the next step after configuring the system to boot into single- user mode?

  1. Reset the root password.

  2. Press the space bar.

  3. Type recovery.

  4. Press the quot;Enterquot; key.

Correct Answer: C

Question No.286

Which command will allow you to quickly determine the administrative status of all interfaces on a Junos device?

  1. show interfaces status

  2. show interfaces summary

  3. show interfaces terse

  4. show interfaces admin

Correct Answer: C

Question No.287

Which two statements are true about the forwarding table? (Choose two.)

  1. The forwarding table lists each source protocol and preference for each destination.

  2. The forwarding table contains only active routes.

  3. The forwarding table is used to process transit packets.

  4. The forwarding table is stored in compact flash.

Correct Answer: BC

Question No.288

What is a valid option when using the ping command?

  1. packet loss

  2. packet size

  3. CRC

  4. TCP port

Correct Answer: B

Question No.289

What is the role of route preference?

  1. It is used as a tiebreaker when the same prefix is available through multiple protocols.

  2. It is used to determine the preferred path to a given destination.

  3. It is used to select the best route between multiple equal-cost paths.

  4. It is used to select which routing table to use for forwarding.

    Correct Answer: A

    Question No.290

    Which two statements are true regarding an Ethernet collision domain? (Choose two.)

    1. If a switch is used, the collision domain is limited to each device and the switch.

    2. If a hub is used, the collision domain is limited to each device and the hub.

    3. If a hub is used, the collision domain includes all devices connected to the hub.

    4. If a switch is used, the collision domain includes all devices connected to the switch.

Correct Answer: AC

Get Full Version of the Exam
JN0-102 Dumps
JN0-102 VCE and PDF

Leave a Reply

Your email address will not be published. Required fields are marked *

Proudly powered by WordPress